Evaluation report ESR-3748, per the ICC Engineering and Inspections Teams, Silca Grate™, manufactured by StoneDeks™, submitted all required certification paperwork, passed the Initial Factory Audit, and is approved for labeling; in completing the certification onboarding process.
Customers and AHJs can view the StoneDeks Systems listing on the ICC Evaluation Services Directory of Reports at this link
ICC ESR-3748, providing evidence that the Silca Grate™ meets code requirements.
The ICC Certification Mark is granted to ICC clients that have successfully been granted an Authorization to Mark (ATM) through a valid ICC Listing Report
Instructional Materials
We are pleased to provide a wide variety of StoneDeks System instructional materials to make your new stone deck construction as quick, smooth, and enjoyable as possible. The following steps will guide you through the process of constructing your new deck and installing your StoneDeks-supported outdoor stone floor.
- Determine the desired elevation of your finished deck floor. There are several important factors to consider during this step, including doorway features and the thickness of your planned outdoor stone floor materials (i.e. natural stone or brick pavers). NOTE: The Silca Grate is 1 1/2 inches thick.
- Build your substructure up to the necessary height with 16 inch on-center floor joists. NOTE: Deck construction must be in compliance with your state and local codes.
- Screw down the Silca Grates to the floor joists using four #9 3″ deck screws per grate. It is recommended that the Silca Grates be staggered to achieve maximum strength and stability. To accomplish this, start one row of Silca Grates with a full grate, and start the next with a half grate. -Be sure that the Silca Grate’s reinforcement straps are on the bottom side, in contact with the floor joists.
- Install Geotextile blanket (ONLY if you are going to use Polymeric sand between the joints of your bricks or pavers).
- Install your new outdoor stone floor!
